Oil Drain Valves
FAQs for "Oil Drain Valves"
Frequently Asked Questions
How do I maintain my fuel and oil drain valves?
Curtis Superior and SAF-AIR valves are designed for installation in a standard NPT port for NPT threaded valves or an AND-10050 style port for UNF threaded valves. Use a thread sealant or Teflon tape on pipe threaded valves. Never allow any thread sealant on the first thread . This will prevent contamination of the fuel system. Refer to aircraft manufacturer's torque specifications for the aircraft in which it is being used.
Replace the rubber seals as per the aircraft manufacturer’s recommendations or every ten years when no guidance is given. McFarlane stocks replacement seals and seal kits for both Curtis Superior and SAF-AIR valves. The new Curtis valves use a O-ring type seal instead of the flat seal that was previously used.
SAF-AIR valves are designed to be disassembled and the O-rings replaced. Over time, if the valve should start to leak, check to make sure the drain valve is tight. If drain valve is found to be tight, then check the O-rings. All O-rings used are buna "n", MS29513 Style, MIL-P-5315. SAF-AIR O-ring seal kits are available for most of their valves. Add a "K" or "-K" suffix to the valve part number.
Never have a hose attached in flight to the oil drain valve. Engine vibration and the additional attached mass can cause premature seal and valve wear which could result in valve failure and a loss of engine oil.
Oil Drain Valves
Large selection, low price!
- Simple operation - spring load close
- FAA-PMA, FAA-TSO-C76 or Mil-Spec approved
- A clean, no mess way to test and drain oil
- Fuel and Oil Quick Drain Valve Information
- Maintenance Tips
Oil Drain Valve Options
SAF-AIR Aviation Products
SAF-AIR has produced high quality close-tolerance valves since 1959. They are unique because their valves have replaceable o-rings.
- Unique o-ring placement prevents leaks by eliminating an area where dirt can gather.
- O-rings can be replaced instead of buying a new valve
- Seal kits available
Curtis Superior Valve Co. Incorporated
Curtis has produced, engineered, manufactured, and tested aircraft valves to exacting standards since 1944. They have many standard valves to solve a wide range of problems.
- Corrosion resistant, stainless steel springs
- Specially compounded "cure dated" synthetic rubber seals to withstand a wide variety of liquids over a broad temperature range
- Unique wedge seal design prevents leakage
Why choose McFarlane?
OUR PARTS ARE ENGINEERED TO LAST LONGER WHILE SOLVING KNOWN SAFETY ISSUES
OVER 40,000 PARTS IN STOCK WITH SAME DAY SHIPPING IF ORDERED BY 3PM
OUR TEAM PROVIDES THE OLD-FASHIONED CUSTOMER SERVICE THAT YOU EXPECT
Select a Category
McFarlane Aviation Family
